"Got to this unit and was able to install parts ordered. After installation of parts tested the unit and found unit to be working correctly. Unit is now heating properly. Got the unit back installed to the appropriate position and tested once again. Unit is working correctly no further issues found at this time. Job complete.

Installed new tubing that sits in drain pan. Recharge system with 156 g of our 134 a. Confirmed good heat transfer at discharge line. Advise to allow 24 hours before temps are back to normal. Job complete.

"Installed new control board. Enter diagnostic mode and perform self check. Confirmed all components working properly, including heater. Job complete."

Found p-trap was not reinstalled properly from previous trip. Issue caused water to back up into refrigerator evaporator pan causing blockage. Unblock drain hole and confirmed unit properly draining. Job complete.

apon arrival i checked behind vaporator panel and seen where it was glossy where water may have been... and after that installing drawers and panel back i checked the driain pipe in the back and found sludge is what me and the customer are calling it and cleared it out and advised customer to monitor unit