Replaced control board job complete

"Installed new moisture sensor due to not drying completely in auto,tested good afterwards

SR# 7741034265 - On arrival confirmed partial frost pattern on evaporator coil again. Tapped system and observed low side pressures running in a 19in vacuum. Pressurized system to 250psi with nitrogen. Exposed all joints and could not locate any leaks using leak detector or bubbles. Spoke with Whirlpool Techline and submitted photos and documented a pressure loss from 250psi to 240psi within 10 minutes. Unit has been submitted for review. Manufacturer will contact customer within 3 business days.

"Cx complaint: no coolUpon arrival, found products in the freezer getting soft. Took the evap cover off. Found a giant ice ball on the cap tube indicative of a sealed system leak, most likely from the evaporator. Cx opted not to repair.

Dryer had a pencil fall into the vent and was noisey till it popped or spit it self out