Cx complaint: noisy operations during spin cycle.Tipped the unit up to inspect lower components. Found grease indicative of a leaking gearcase. Cx declined repair.

Got back to this unit and did more testing thought that the unit was beginning to drain better than with more testing found exactly the opposite. With the belief that we were about to change the drain pump started back into taking the unit back apart and decided to check a little bit further into the tub only to find two different bra inserts that were completely clogging the bottom of the drainwas almost 4 inches up into the bottom of the tub. After these parts were removed put the unit back through testing to find it to be draining. Extraordinarily well. No further issues found at this time job complete.

Found front right burner flame not touching igniter head while on lowest setting. Adjusted flame to a higher setting so the flame is touching the igniter. Head to prevent sparking. Unit checks OK now. Job complete.

"Replaced right side, freezer drawer bracket. Confirmed drawer locked in place properly now. Job complete."

"Installed new compressor and recharged system with 56 g R600. Advise Mr. to allow 24 hours before unit is back to normal temps and icemaker start to produce .Job complete.