Called techline and through testing found he needed to change water filter as there was barely any ice sitting in ice tray also tested unit again and found ice cup being filled properly but while looking at ice maker found the clip that holds the thermistor in place against the mullen was not there so put new ice maker and with one that had it and tested fill test and advised customer to monitor unit and call us back if no ice

Installed new nameplate and took apoxy i had and patched up the little hole as the kit need the unit to be a certain degree which ment unplugged and 24hrs to dry which was not going to work for customer

Installed new UI and confirmed it is now reconizing the doors opening and closing as it should.... Advised customer to monitor unit and contact us if there are any further issues

Installed new pressure switch and HMI and advised customer to monitor unit as he says sometimes it works fine and sometimes dont be if he calls back will need 2 people to install main control as the unit needs to be pulled out and a tech jump behind as it is in a small closet

Installed new ring and new user interface and unit was able to let me test each valve and i tested fabric softener over and over after finding the front left leg had dropped down again... so retightened that really good and hopefully it stays level but could not find any leaks